This evaluation board hosts the LPC2929 or LPC2939 microcontroller from NXP with an embedded ARM968E-S processor core and with an JTAG interface. In addition the driver chips for the external communication interfaces are included. All microcontroller IO port pins are accessible via connectors. The device drivers can be disabled via jumpers to have control of the microcontroller IO pins.

Evaluation board with

• Hitex Evaluation Board for ARM with NXP ARM9 microcontroller LPC2929 or
• Hitex Evaluation Board for ARM with NXP ARM9 microcontroller LPC2939
• support for internal 768kByte FLASH and 80kByte SRAM
• support of 2 CAN and 2 RS232 ports
• external SRAM 512k x 8 (limitation for evaluation board V1.0)
• 2 x small 7-segment LEDs attached to port pins
• 3 buttons for reset, IRQ and port pin
• 32,768kHz + 16MHz Quartz
• configuration of ports, reset, etc. via jumpers
• JTAG debugger support with JTAG connector
• 2 x 24 pin connector for BLDC motor add-on board
• 1.8V and 3.3V power regulator,+5V directly from USB
• USB device support
• USB-OTG device support (LPC2939 only)
• USB powered or alternative external power via BNC connector
• 5V Poti to evaluate ADC
• power, reset and enumeration LED indicator
• PCB, size 152x138mm

The Kits includes

• Hitex Evaluation Board for ARM with NXP ARM9 microcontroller LPC2929 or
• Hitex Evaluation Board for ARM with NXP ARM9 microcontroller LPC2939

• CD-ROM with
  • Examples for Keil and HiTOP
    - Keil : RAM application with USB HID
    - HiTOP: 5V ADC demonstration
  • The Board schematic as reference design

• An USB-cable (A - MiniB)